THANK YOU FOR SUBSCRIBING

The Stigma of Job Site Inspections


As a Safety Manager in the construction industry, there has always been a stigma with safety inspections or audits and the documentation of observations. A paranoia that sets in with the job site managers when observations are documented and viewable in black and white. So how do we alleviate this stigma and create a positive safety culture while feeling encouraged to do so? In the end, the objective is to create transparency within a safety program to create a positive safety culture and that can only be accomplished if the safety program is understood by everyone in the company. In California, the safety program is known as the Injury and Illness Prevention Program (IIPP). The IIPP is supported by several detailed programs such as heat illness, confined spaces, silica exposure, and many more depending on a company’s method of operation. For this article, we’ll narrow our focus down to the IIPP and a few of its sections.
First, it’s important for management to buy in to the IIPP from the beginning. This usually isn’t a problem if management is involved in the process of developing and updating the program.
The State of California requires the program to exhibit nine sections: responsibility, compliance, communication, hazard assessment, accident/incident investigation, hazard correction, training, recordkeeping, and employee access to the IIPP. We can further narrow this conversation down to the sections on responsibility, hazard assessment, hazard correction, and recordkeeping. If the responsibilities are clearly defined and each level of management and labor understand those responsibilities, there should be no misinterpretation, if one or a few of those responsibilities involve hazard assessment, hazard correction, and recordkeeping.
Safety programs are an animal that feeds off documentation; “if it’s not on paper, then it didn’t happen”, would be the mantra and ill effects of not feeding the animal. I use the analogy of an “animal” because an IIPP is a living, breathing document that is meant to change with the times and the company’s and states regulatory standards. If observations are discovered during a hazard assessment (inspection) they would obviously be documented and therefore any corrections would also be documented. At this point, the stigma should end there with the negating of a hazardous observation with a correction that plans to prevent recurrence of that hazard.
As an inspector walks through their inspection there must be communication with the site supervisors, whether they are subcontractor or general contractor supervisors, each item should be discussed and distributed for review and corrective action to take place.